![]() IKE Config Push - Gives a computer the opportunity to offer settings to the client through the configuration process. ![]() With the support of the Pull method by the computer, the request returns a list of settings that are supported by the client. IKE Config Pull - Allows setting requests from a computer by the client.Disabled - disables any automatic client configurations.The available options are defined as follows: ![]() In the Auto Configuration drop-down list, choose disabled. For the VPN to work, the tunnel uses UDP port 500 which should be set to allow ISAKMP traffic to be forwarded at the firewall. Note: Ensure that the Port number is set to the default value of 500. In the Remote Host section under the General tab, enter the public Host Name or IP Address of the network you are trying to connect to. The VPN Site Configuration window appears. Open Shrew VPN Access Manager and click Add to add a profile. Click Add Row to add user accounts, used to authenticate the VPN clients (Extended Authentication), and enter the desired Username and Password in the fields provided. Navigate to VPN > IPSec VPN Server > User. The settings are based on the document, Configuration of an IPSec VPN Server on RV130 and RV130W, and will be referred to in subsequent steps. Note: The above settings are an example of an RV130/RV130W IPSec VPN Server configuration. If the IPSec VPN Server is not configured or misconfigured, refer to Configuration of an IPSec VPN Server on RV130 and RV130W and click Save. Verify that the IPSec VPN Server for the RV130 is properly configured. Log in to the web configuration utility and choose VPN > IPSec VPN Server > Setup.
0 Comments
Leave a Reply. |